Drilling Cuttings is the primary strong to pollute the going fluids in the oil as well as gas industry. The going speed runs slow if the solids in the drilling water going up. In order to keep the efficiency of the drilling fluids, it is necessary to control the drilling ensity. According to the survey, the actual of drilling fluids is often 10 or 20 times during the the drill cuttings. A small part of the drilling water is used to expand often the drilling hole. So is considered pretty cost-effective to use mechanised separation equipment to fulfill typically the objectives of eliminate the unsafe solids and decrease the use of drilling fluids to cut price.
High speed decanter centrifuge can easily separate most of the solids bigger than 2-5 microns. The right after treated solids are with less water which can save drilling fluids largely, so centrifuge has a great market inside solids control area.
GN Decanter Centrifuge Description and also Innovations
1 . GNLW363 plan and sedimentation decanter centrifuge is one equipment using centrifugal separation to eliminate finder solids and keep the drilling mud characteristics and content firm, and meet the need involving save cost for drilling mud.
2 . Project Issues:
a. The wear weight of screw propeller.
udemærket. The running through in the solids discharge port.
a few. The Main Parameters
Internal Height of Rotating Bowl: φ360mm
Working Length of Rotating Bowl：1271mm
Rotating Speed: 3200rpm
Spliting up Factor: 2062
Taper Position of Rotating Bowl: 17°
Spiral Type: single brain, right rotate, lag
Potential. Treating Capacity: 30m³/h
Minute. Cut Point: 2～5μm
some. Innovations:
a. Screw propeller is fixed with compatible tungsten carbon tiles.
f. Discharge port is set with scraper to discharge typically the solids automatically.
Related Posts
Valuable for information.. Is there any further reading you would recommend on this?
ReplyDeleteAlly
High Speed Centrifugei