GN Decanter Centrifuges are very common to separate OBM, WBM or maybe SBM. GN decanter centrifuges are designed and manufactured by knowledge engineers who have been working on solids control and drilling waste management systems for many years.
Drilling Cuttings is the primary strong to pollute the going fluids in the oil
as well as gas industry. The going speed runs slow if the solids in the
drilling water going up. In order to keep the efficiency of the drilling
fluids, it is necessary to control the drilling ensity. According to the
survey, the actual of drilling fluids is often 10 or 20 times during the the
drill cuttings. A small part of the drilling water is used to expand often the
drilling hole. So is considered pretty cost-effective to use mechanised
separation equipment to fulfill typically the objectives of eliminate the
unsafe solids and decrease the use of drilling fluids to cut price.
High speed decanter centrifuge can easily separate most of the solids bigger
than 2-5 microns. The right after treated solids are with less water which can
save drilling fluids largely, so centrifuge has a great market inside solids
GN Decanter Centrifuge Description and also Innovations
1 . GNLW363 plan and sedimentation decanter centrifuge is one equipment using
centrifugal separation to eliminate finder solids and keep the drilling mud
characteristics and content firm, and meet the need involving save cost for drilling
2 . Project Issues:
a. The wear weight of screw propeller.
udemærket. The running through in the solids discharge port.
a few. The Main Parameters
Internal Height of Rotating Bowl: φ360mm
Working Length of Rotating Bowl：1271mm
Rotating Speed: 3200rpm
Spliting up Factor: 2062
Taper Position of Rotating Bowl: 17°
Spiral Type: single brain, right rotate, lag
Potential. Treating Capacity: 30m³/h
Minute. Cut Point: 2～5μm
a. Screw propeller is fixed with compatible tungsten carbon tiles.
f. Discharge port is set with scraper to discharge typically the solids